### Our Services

Get 15% Discount on your First Order

# BCIT Department of Physics MGO-03 – Worksheet Version: Jan-23 – 1 – © Dr. M. Harder MGO-03: Graphical Analysis – Worksheet Maximum Score: 18 1. [4]

BCIT Department of Physics MGO-03 – Worksheet

Version: Jan-23 – 1 – © Dr. M. Harder

MGO-03: Graphical Analysis – Worksheet

Maximum Score: 18

1. [4] Include the following four GraphIt outputs (plot and fit results) with your submission:

(1) Data Set 1 fit with Model 1.1
(2) Data Set 1 fit with Model 1.2
(3) Data Set 2 fit with Model 2.1
(4) Data Set 2 fit with Model 2.2

Ensure that: (i) Your axes are properly labelled, including units; (ii) Your graph has an
appropriate title; (iii) You follow the formatting requirements of Sec. 2 in the
introduction.

From now on all of these conditions must be met as a default when submitting any
plot.

2. [1] For Data Set 1, write out the relationship between Model 1.1 and the hypothesis.

The answer for this question is:

𝒚 = 𝑽; 𝒙 = 𝑰; 𝑨 = 𝑽𝟎; 𝑩 = 𝑹

You can simply write out this answer on your worksheet. The reason I am writing it
here is so you know what I mean when I ask for “the relationship between the model
and hypothesis equations, and you can now perform this same analysis for the other
hypotheses and models in this experiment.

3. [1] Write out your fit equation for Data Set 1, using Model 1.1. Ensure: (i) That you use
the appropriate variables and that all fit coefficients: (ii) Include uncertainties; (iii) Are
properly rounded; and (iv) Include appropriate units.

From now on all of these conditions must be met as a default when writing out any fit
equation, in any experiment we do.

4. [1] Based on your fit, is 𝐴 consistent with zero? In other words, does 𝐴 overlap with zero

within experimental uncertainty?

5. [1] For Data Set 1, write out the relationship between Model 1.2 and the hypothesis.

6. [1] Write out your fit equation for Data Set 1, using Model 1.2.

MGO-03 – Worksheet BCIT Physics Department

– 2 – © Dr. M. Harder

7. [1] Based on your answer to question 3 and the conditions for selecting an appropriate
model equation (see p. 2 of the MGO-03 lab description), should you use Model 1.1 or
Model 1.2 to fit Data Set 1?

8. [1] For Data Set 2, write out the relationship between Model 2.1 and the hypothesis.

9. [1] Write out your fit equation for Data Set 2, using Model 2.1.

10. [1] For Data Set 2, write out the relationship between Model 2.2 and the hypothesis.

11. [1] Write out your fit equation for Data Set 2, using Model 2.2.

12. [2] Show your calculation of ρ and Δρ using Data Set 2 and your Model 2.2 fit.

13. [1] State your final result for ρ ± Δρ. Make sure to properly round your result, and

include your uncertainty and units.

From now on, all of these conditions should be met by default when stating an
experimental result.

14. [1] Would you choose Model 2.1 or 2.2 to fit Data Set 2? Explain your reasoning.

#### Share This Post

Order a Similar Paper and get 15% Discount on your First Order

## Related Questions

### PLEASE REVIEW THE INFORMATION BELOW  Image Characteristic for Mirror and Lens A spherical mirror is a reflective surface that

PLEASE REVIEW THE INFORMATION BELOW  Image Characteristic for Mirror and Lens A spherical mirror is a reflective surface that can be concave or convex. Making the analogy with a spoon, the reflective surface of a concave mirror (spoon) “holds” the water and the reflective surface of a convex mirror (spoon)

### PLEASE REVIEW THE INFORMATION BELOW  Reflection and Refraction Reflection and refraction are two commonly observed optical properties of light.

PLEASE REVIEW THE INFORMATION BELOW  Reflection and Refraction Reflection and refraction are two commonly observed optical properties of light. Whenever light strikes the surface of some material at an angle, part of the wave is reflected, and part is transmitted (or absorbed). The reflection of light rays from a plane

### I need help with this home work assignment  Practice Makes Perfect – Final Comprehensive Quiz

I need help with this home work assignment  Practice Makes Perfect – Final Comprehensive Quiz General Physics Lecture/Lab (PHY 213) V. M. Edwards, Ph.D., Professor Last Name__________________________ First name______________________ Score___________ SI Base Units Quantity SI Unit (word) SI Unit (abbreviation) 1. Mass _________________ _________. 2. Time _________________ _________. 3. Length

### Read Extortion – the short sci-fi story. After you finish the story, look up the discussion questions ( using discussion questions attachment ONLY!!) ,

Read Extortion – the short sci-fi story. After you finish the story, look up the discussion questions ( using discussion questions attachment ONLY!!) , choose twenty (20) which you find especially interesting, and write a short answer for these using ONLY!! the extortion document attached.

### please review the info below Magnetic Fields This lab uses a Physlet simulation. Click here

please review the info below Magnetic Fields This lab uses a Physlet simulation. Click here In this lab the simulation generates magnetic field lines due to permanent magnets such as ferromagnetic materials (like iron) and Earth. Magnetic field “lines” are actually loops with a North to South direction. Magnets have

### I need help with these homework problems 1. The amplitude of the wave shown in the figure is A. A. B. B. C. C. D. D. 2. The wavelength of the

I need help with these homework problems 1. The amplitude of the wave shown in the figure is A. A. B. B. C. C. D. D. 2. The wavelength of the wave shown in the figure is A. A. B. B. C. C. D. D. 3. What is the wavelength

### PLEASE REVIEW INFORMATION  Ohm’s Law Theory Ohm’s law states that the current through a conductor

PLEASE REVIEW INFORMATION  Ohm’s Law Theory Ohm’s law states that the current through a conductor between two points is directly proportional to the voltage across the two points and inverse proportional with the resistance. V = I R V = Voltage I = Current R = Resistant Procedure The lab

### PLEASE REVIEW THE INFO  Experiment

PLEASE REVIEW THE INFO  Experiment Pendulum and the Calculation of g Experiment Pendulum and the Calculation of g Lab 6 -Simple Pendulum Discussion and review A simple pendulum consists of a mass (“bob”) suspended from a light string of length L. The bob is pulled sideways such as the string

### I am looking for someone to help me solve the attached question  image1.png

I am looking for someone to help me solve the attached question  image1.png

### please review the info  Conservation of Energy Name: Date: Objectives: To explore concepts of kinetic, potential and total

please review the info  Conservation of Energy Name: Date: Objectives: To explore concepts of kinetic, potential and total energy with and without friction. Theory: Kinetic Energy, KE=½mv2. Gravitational Potential Energy PE=mgh Total Mechanical Energy, E=KE+PE= mgh + ½mv2 Conservation of energy law: Ef = Ei or Ef – Ei =

### info below FRICTION The lab activity uses a simulation developed by University of Colorado Friction Simulation

info below FRICTION The lab activity uses a simulation developed by University of Colorado Friction Simulation Click Here Select “Friction” on the bottom of the screen, then select all the right corner options. Start with the m=50kg wood box on the floor and increase the applied force such as the

### INFROMATION BELOW  Lab 3 – Force 1. What is force? 2. What is the unit for force? 3. Analyze each vector diagram and fill

INFROMATION BELOW  Lab 3 – Force 1. What is force? 2. What is the unit for force? 3. Analyze each vector diagram and fill in the table below. Vector Diagram Resultant Force (Magnitude and Direction) 4. What is the force on a 1000 kg elevator that is falling freely at

### PLEASE REVIEW THE INFO Data Collection: Linear Motion Linear motion refers to the motion of an object along a straight

PLEASE REVIEW THE INFO Data Collection: Linear Motion Linear motion refers to the motion of an object along a straight line. This experiment will study in activity 1 the linear motion in a horizontal direction and in activity 2 the linear motion in a vertical direction. Material you need: ·

### Can someone help me with this homework assignmen? Only 15 questions. Last Name _____________________________ First Name ____________________ Major

Can someone help me with this homework assignmen? Only 15 questions. Last Name _____________________________ First Name ____________________ Major _________________ 1. Complete the following statement: The angular measure 1.0 radian is equal to A) 0.0175°. B) 57.3°. C) 1.57°. D) 3.14°. E) 6.28°. 2. A bicycle travels 141 m along a

### please review the information below . Measurements of Length and Time Objectives

please review the information below . Measurements of Length and Time Objectives To make basic measurements of length and time To practice graphing using spreadsheet software and paper and pencil. 1. Length · Estimate a 1-meter length by putting a pen or pencil at one end of a table and

### Graphing Lab PHSC 114 Southern Arkansas University TECH Spring ‘23 Lab 3- Graphing Introduction: One of the most effective methods of

Graphing Lab PHSC 114 Southern Arkansas University TECH Spring ‘23 Lab 3- Graphing Introduction: One of the most effective methods of describing the relationship between two or more types of measurements is to plot a graph. For example, you could plot a graph of distance vs. time and this would

### Last Name ___________________________First Name _______________________Date ______________ 1. A park ranger wanted to measure the height of a tall tree.

Last Name ___________________________First Name _______________________Date ______________ 1. A park ranger wanted to measure the height of a tall tree. The ranger stood 9.50 m from the base of the tree; and he observed that his line of sight made an angle of 65.2° above the horizontal as he looked at